I picked up the Large Hall Construction from Patrick Miniatures last week and I started printing. After finding out it really is a bit massive.....I started printing more.
But with 1 intact, 1 damaged and 1 destroyed part for each part it started to get repetevive quick. So I started with just cutting the lengthway beams down the middle and adding a mirror copy of the sliced side to it. Nothing rocketsience. Then I raised the bar a bit and spliced the underside of the broken column onto the top of the damaged column, to get that fine quality Russian concrete work feel that makes you eat a OSHA book. And then repeated that for the side columns.
They printed off fine, and I just got back from picking up some MDF sheets 40x23 so I can base it up 2 spars at a time, going from ok to knackered. The slots in between I'll use a marker mould to drill in holes for putty and magnets so I can click in the lengthway concrete beams. If I place down the full set you cover a space over a metre long and 40 cm wide.....a table all on its own tbh.
It was meant for Stalker....but tbh, should work fine for Historical, Necromunda, other Post Apoc etc.
Geen opmerkingen:
Een reactie posten